Be-elastic Snap Legs | Creates A Table Out Of Any Flat Surface

$125

We’ve all been in a situation where we have guests over but not enough room for an extra table, so everything gets crowded and messy. If you ever experienced something like that, then you’re really going to like this new, simple but cutting-edge product. We present you SNAP Legs by Be-Elastic. With these clip-on legs, you can make a table from any flat surface in your home in a matter of seconds.

These Snap legs by Be-Elastic were designed by a couple of Spanish designers, Maria Roca and Erika Biarnes. These two created a very simple, yet very practical solution when it comes to improvised furniture. Setting up these table legs don’t require any kind of drilling, gluing or any kind of tool so you don’t have to worry about the mess, you can just easily put them on and off whenever you need a table. And everything can be a table with these legs, as long as it’s a flat surface. You can use a dart board, a larger book, any piece of flat wood, literally anything that can pose as a table.

Two tables photographed from above.

These Snap legs are easy to use and they don’t require glue or tools.

Snap legs are very easy to use. Since the top end was made to resemble some sort of clamp, you just need to bend the lower part in order to open it and attach it to the table. After you release the bottom end, two parts will press against the table and that will provide the needed stability and balance. That simple clamp system is also supported with a PVC-coated cable that you’ll have to attach to the one of the upright supports of the leg’s structure. It’s very simple, you just need to put PVC cable through a small but visible hole on the leg. If you use a strong flat surface, 4 of these Snap legs will be able to withstand up to 98 kg (216 pounds) in weight which is more than enough for a table.

Snap leg captured form the front.

They are made of steel and covered with epoxy paint.

Snap leg is being attached to the table.

Snap legs can support any kind of flat surface from 1 to 4 cm thick.

The first thing that will catch your eye certainly is the clamping system, but bear in mind that the PVC cable is crucial for the stability of the whole thing. So, you must not forget to put everything in place before using these Snap legs by Be-Elastic. It’s also very important to say that the clamps can support flat surfaces of any shape, just as long as they’re from 1 to 4 cm thick. The Snap legs are made of steel that’s covered with epoxy paint, so they’re very durable.

Finally, you now have the opportunity to easily set up a table for you and your guests in a matter of seconds. And if at some point you decide that you don’t need it anymore, you can easily disassemble it.

Get it from Huckberry here.

Woman placing a book on the table.

4 of these legs can withstand up to 98 kg of weight.

A round table captured from above.

The clamp system is also supported with a PVC-coated cable that will provide you with even more stability.

Check out what else can easily become a table with these Snap legs by Be-Elastic.


Daily Newsletter

Subscribe to Jebiga for a dose of the best in gear, design, rides, tech and adventure.